- Motor Mounts (Each) - 034 Density for B6-B7 S4, C5 A6-S6-allroad V8 and B7 RS4
Motor Mounts (Each) - 034 Density for B6-B7 S4, C5 A6-S6-allroad V8 and B7 RS4
JHM Oil Separator Heater Bypass Kit for B8-S5 4.2L FSI V8$11.95Add to Cart | Wishlist
Exhaust - Race Pipe - Stainless Steel (JHM) for B9 S4-S5 3.0T$1,199.95Add to Cart | Wishlist
JHM contacted their friends over at 034 Motorsports to bring their tried and true Density Line of Motor Mounts to the V8 market in 2010. They obliged us by building them in a few short months. We knew they would work great since we have used their density line mounts on our in house and customers B5 S4s for many, many years. We have built many B5 S4s over the years that ran 11 second quarter miles with these mounts and held up to numerous tire spinning launches. Another great feature about these mounts is that they are affordably priced for those looking for a lower cost performance replacement mount that costs less than anything else on the market. So here they are.
- STREET density rubber (10% stiffer than stock)
- Factory fitment
- Heavy duty steel bottom casing
- OPTIONAL: Electronic circuitry disabled, if you do not want to have codes stored in your ECU please purchase 034-708-0000 for a resistor to install. 1 per mount needed. This does NOT cause a Check Engine light it is just a soft code that some people do not like to have.
- 2003-08 B6-B7 Audi S4 All
- 2006-2008 B7 Audi RS4 All
- 1999-2005 C5 Aud A6-S6-RS6 w/ V8 motors
Sold as individual mounts. Make sure you change the quantity to 2 during checkout if you need both. If you do not want engine mount codes make sure you select the optional resistor to plug into the factory harness and eliminate any possible codes.
NOTE: These mounts sometimes have cosmetic blemishes in the steel casings which occur in transit from 034Motorsport's manufacturer to their location. The rubber is so deeply embedded in the steel casing during the manufacturing process that this does not affect durability or performance of the mount.
For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.
|Audi||allroad||C5 (2001-2005)||4.2l V8 40v|
|Audi||S4||B7 (2005.5-2009)||4.2l V8 40v|
|Audi||RS4||B7 (2006-2009)||4.2l V8 32v FSI|
|Audi||S4||B6 (2003-2005)||4.2l V8 40v|
|Audi||A6||C5 (1998-2004)||4.2l V8 40v|
|Audi||S6||C5 (2002-2003)||4.2l V8 40v|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov