- Transmission Rebuild Kit, 0A3 MT (JHM-Performance), MINIMAL, Seals and Synchros ONLY for B6-B7 S4 and RS4
Transmission Rebuild Kit, 0A3 MT (JHM-Performance), MINIMAL, Seals and Synchros ONLY for B6-B7 S4 and RS4
JHM R Series Lightweight Flywheel (Chrome-Moly Forged) and Clutch Combo for B7-RS4
Select options & add to cart to view final price
INTRODUCING THE JHM PERFORMANCE 0A3 TRANSMISSION REBUILD KIT!
JHM Performance Carbon Synchros:
We have been testing and abusing our JHM Performance Carbon Synchros for the 0A3 Transmission since 2013 in our Supercharged S4 and RS4s. We have been putting them to the ultimate test to make sure they can handle all the abuse we throw at them. We have improved upon the OEM Design featuring an improved coefficient of friction VS OEM which will result in better high RPM shifting. Our oiling grooves will provide better cooling to the synchros increasing the durability making them longer lasting. Best of all, they cost less than OEM synchros making these an incredible bang for your buck.
Fits all 0A3 transmissions found in the B6-B7 S4 and the B7-RS4
Is your transmission going bad? Do you have synchro issues and gear crunching? Do you have trouble getting into gear? Is your shifter randomly popping out of gear? If you want to fix your transmission issues right the first time then this is the rebuild kit for you!
Our FULL 0A3 Rebuild Kit INCLUDES THE FOLLOWING: (**NOTE: This is our MINIMAL rebuild kit for the 0A3 Transmission and DOES NOT include the OEM, UPDATED 2nd gear and 1-2 Shift Collar. If you are interested in our FULL Kit or our 2nd GEAR REPAIR Kit, please go back to the "Shifters, Trans, and Drivetrain" Section and select either of those kits.)
- JHM-Performance 3-piece Synchronizer rings (6)
- OEM, UPDATED 1-2 Shift Collar or Synchro Hub
- OEM, UPDATED 2nd Gear
- OEM Input Shaft Seal
- OEM Input Shaft Seal C-Clip
- OEM Input Round Seal or O-Ring
- OEM Selector Shaft Seal
- OEM Front Output Shaft Seals (2)
- OEM Rear Differential O-Ring Seal
- OEM Selector Shaft O-Ring Seal
- OEM Rear Output Shaft Seal
- OEM Selector Shaft Detents (2) Even though these detents are reusable we include them for several reasons. It's best to replace the two detents at the selector shaft. Also, on some early 2004 S4s there was a reverse lockout issue and these updated detents fix that issue. Finally, sometimes these detents get damaged upon removal so it is good to have replacements when doing a rebuild.
If you've got "crunching" while shifting or any of the symptoms described above, do not push the rebuild down the road and increase your costs when you finally rebuild the transmission. Look what happens to gears and collars when the symptoms are ignored:
Click to enlarge picture
OPTIONS: If you do not need the complete kit or need just the parts to make a repair please email firstname.lastname@example.org for pricing. We do not offer them separate without talking to our customers. We want to speak with you and make sure you get exactly what you need.
VIEW INFORMATIONAL VIDEO ABOUT THE LINKAGE ON THESE CARS -->HERE
The retail price on these from a dealer as of 8-1-2012 is over $2000 if you can get them to help you pick out rebuild parts and not just try to sell you a complete transmission. So you save almost $400 by going with our Rebuild Kit. If you are NOT in CA you will save on tax as well.
NOTE: Kits usually ship out from our location within 1 to 4 days depending on our current stock.
We also provide this rebuild service here at our shop in Lathrop, CA. Please contact us at email@example.com to get an estimate for your rebuild.
Click to enlarge picture
For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.
|Audi||S4||B7 (2005.5-2009)||4.2l V8 40v|
|Audi||S4||B6 (2003-2005)||4.2l V8 40v|
|Audi||RS4||B7 (2006-2009)||4.2l V8 32v FSI|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov