Select Vehicle From Dropdown

Stainless Braided Turbo Oil Line and Strainer/Screen Relocation Kit (JHM-Serviceable) for TSB-2044640 on C7 S6-S7-RS7 and D4 A8-S8 4.0T

SKU: JHM-079115175G-TSB-2044640

$549.95

Details
Details

THE ORIGINAL FULLY ENGINEERED SOLUTION SINCE 2018!

JHM Stainless Braided Turbo Oil Line and Strainer/Screen Relocation Kit (Serviceable) for C7-D4 4.0T.

We are pleased to offer our JHM Stainless Braided Turbo Oil Line and Strainer/Screen Relocation Kit. This product was designed to make your life easier, save you money over the long run, and help keep your turbos alive.  This is the solution to the pesky OEM Oil Strainer/Screen that gets clogged over time which inevitably starves your turbos of oil (TSB-2044640). When your turbos are starved of oil they will fail which will cost you thousands of dollars to replace. With our JHM Stainless Braided Turbo Oil Line and Strainer/Screen Relocation Kit, you no longer use the factory Oil Strainer/Screen (079115175G) and instead uses two oil screen filters that are relocated on top of the motor where they are easy to get to and can be serviced as often as you like! To replace your OEM Oil Strainer/Screen is a lengthy process which requires you to put your vehicle into service position, remove the throttle bodies, intercooler, bi-pipes, oil separator, etc. just to get to the screen.  With our kit, you only have to perform this job ONCE saving you this costly service every time you want to clean your filters. This is a No-Brainer upgrade. 

 

100% BOLT IN - NO CUTTING OR MODIFICATIONS TO YOUR CAR REQUIRED!

COMPATIBLE WITH FACTORY AND UPGRADED TURBOS THAT RETAIN THE USE OF THE OEM OIL FEED LINES

 

Features:

• High-Quality 304 Stainless Steel Fittings
• High-Quality 304 Stainless Steel Braided Lines
• High-Quality Aluminum Oil Screen Housings
• High-Quality Oil Strainer/Screens (Factory Matched Micron)
• High-Quality Delrin Strainer Blank
• High-Quality Velcro Heat Sleeve 

Our filters feature a dome-shaped design that not only increases the surface area of the strainer but also helps prevent complete clogging of the strainer as the OEM strainer is known to do. Instead, if the filter has been neglected it will push debris in the oil down and off to the side which will still allow the oil to flow through the strainer.

Our lines are made of the finest PTFE hose and permanently crimped-on zinc plated steel fittings. Our lines are made with an extruded PTFE core and a stainless steel wire braided cover. For added protection against abrasion and corrosion, all of our lines feature a clear PVC outer cover.  Other colors may be available in the future.  Note: The clear PVC Cover can develop a slight yellow tint over time due to engine temps. This is not an issue and does not affect the abrasion resistance of the PVC.

 

 Line Installation Video

For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.



This product fits the following vehicles:
Make Model Chassis Engine
Audi RS7 C7-C7.5 (2014-Present) 4.0t V8 32v
Audi S6 C7-C7.5 (2013-Present) 4.0t V8 32v
Audi S7 C7-C7.5 (2013-Present) 4.0t V8 32v
Audi S8 D4-D4.5 (2013-Present) 4.0t V8 32v
Audi A8 D4-D4.5 (2011-Present) 4.0t V8 32v
Reviews
Write Your Own Review
You're reviewing: Stainless Braided Turbo Oil Line and Strainer/Screen Relocation Kit (JHM-Serviceable) for TSB-2044640 on C7 S6-S7-RS7 and D4 A8-S8 4.0T
Off-road Use

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Prop 65

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov

Q and A

Product Questions

No questions yet. Be the first to ask the question!
You may also be interested in the following product(s)