Select Vehicle From Dropdown

Flywheel (LUK-OEM updated) for 04 and up B6/B7 S4

SKU: LUK-079105266E
$675.00
Details
Details
NOTE: JH Motorsports has seen many B6 S4 flywheels fall apart in some cases causing major damage to the transmission. This is why JHM built all its clutch and flywheel products around the new and updated B7 style flywheel and pressure plate. This way we can update all B6 owners to B7 spec components. Our complete kits fit ALL B6/B7 S4 4.2l V8s, we basically take the guesswork out of updating your B6 to B7 specs.

This flywheel is for existing B7 S4 owners or B6 S4 owners who have already purchased our B7 S4 Performance clutch kit or an OEM B7 S4/RS4 clutch kit. NOTE: This will not work properly with the B6 S4 pressure plate. If you insist on staying with the B6 S4 clutch which has a weaker clamp load than the B7 clutch we can get you an OEM B6 S4 flywheel for this price as well, just ameil us at sales@jhmotorsports.com.

SPECS
- FLYWHEEL - These are the latest and greatest OEM B7 (05.5 and up) flywheels. These are a direct replacement for 05.5 and up B7 S4s and an upgrade for 04-05 B6 S4s. So if you have a B7 or B6 with a beatup or broken flywheel and want the same dual mass flywheel as stock with a brand new OEM clutch this combo is for you. We only sell these OEM flywheels due to the high failure rate of the B6 S4 flywheel so it is best for them to upgrade to B7 flywheels. An added bonus to this upgrade for the B6 S4 owners is that with this flywheel you can now run a B7 S4/RS4 pressure plate that is in our JHM clutch and this OEM replacement kit. The higher clamp load pressure plate from the B7 S4/RS4 is not compatible with the OEM B6 flywheel, so you must run a JHM lightweight flywheel or a B7 S4 OEM flywheel.

INCLUDES THE FOLLOWING -OEM updated B7 26.5lb Flywheel - New pilot bearing (already pressed in). Don't forget to purchase 8 new flywheel bolts also available in this section, these MUST be replaced.

NOTE: Flywheel to Crankshaft bolts must be torqued to 45 ft lbs plus an additional 90 degrees. Pressure plate to flywheel bolts must be torqued to 18 ft lbs and JHM recommends the use of loctite here as well.

For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.


This product fits the following vehicles:
Make Model Chassis Engine
Audi S4 B7 (2005.5-2009) 4.2l V8 40v
Audi S4 B6 (2003-2005) 4.2l V8 40v
Reviews
Write Your Own Review
You're reviewing: Flywheel (LUK-OEM updated) for 04 and up B6/B7 S4
Off-road Use

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Prop 65

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov

Q and A

Product Questions

Hi,
Will this fly wheel fit early model B6 S4?
Also, if there is any, what is the difference in early and late model B6 S4 Flywheel?
Thanks
0
You may also be interested in the following product(s)