• JHM Solid Linkage Upgrade for C6 A6 & B6-B7 A4, 2004-on (6-Speed) - 01X-02X
Select Vehicle From Dropdown

JHM Solid Linkage Upgrade for C6 A6 & B6-B7 A4, 2004-on (6-Speed) - 01X-02X Zoom

JHM Solid Linkage Upgrade for C6 A6 & B6-B7 A4, 2004-on (6-Speed) - 01X-02X

Be the first to review this product

SKU: JHM-LNK-B6B7A46S

$199.95

Featured Products

Related
Details
Details
PROUDLY DESIGNED AND BUILT IN CALIFORNIA

NOTE: This shifter does not work on the 02 and 03 3.0l V6 A4 with the 01E manual transmission. This is for the 04 and up 1.8t, 2.0t , 2.0t TDI and 3.0l V6 with the 02X and 01X manual transmission. This shifter works on ALL C6 A6s and B7 A4s with 01X or 02X transmission with no exception, the exception is only for B6 A4s since this does NOT work on the 01A 5-speed. See the 5-speed product page if your B6 A4 is equipped with a 5-speed.

If you desire the ultimate in shifting, the JH Motorsports B6/B7 A4 Solid Linkage Upgrade is the perfect solution. This linkage upgrade replaces the OEM rubber/plastic socket assembly with a steel spherical bearing (similar to what the JHM Solid Shifter does for the OEM shifter box). This will give you a full mechanical race car feel, and eliminates sloppiness allowing you to optimize shifts on the street or at the track. The linkage is most purposeful when used with the JHM Solid Shifter and the JHM Delrin Shifter Stabilizer Bushing, however these parts will compliment any SS kit, including stock shifters.

To completely upgrade your stock shifting components for the best possible shifts, make sure to add our Solid Short Throw Shifter and the Solid Stabilizer Bushing to your order if you do not already have them.

B6-B7 A4 Solid Shift Linkage Upgrade


INCLUDES THE FOLLOWING - JHM shift shaft link (reuse your stock boot), JHM Modified Steel Spherical bearing, stainless steel spacers, all hardware, loctite and synthetic grease.

(This linkage is located at the transmission and is separate from our shifter) This linkage fits all B6/B7 A4 6-speeds, 2004 and On. The removal of the linkage rod is not too bad on the 1.8t and the 2.0t since it is located on the drivers side (Opposite side of where the downpipe is).

COMES AS A COMPLETE DO IT YOURSELF KIT Cutting is required to allow proper clearance.

VIEW COMPARISON VIDEO -->HERE
NOTE: This video was done on a B5 S4 which has the same basic design and works in the same fashion, the B6/B7 A4 linkage just looks a little different and has a shorter cross rod.

VIEW INSTALLATION INSTRUCTIONS -->HERE
NOTE: These instructions only cover the installation of only the actual kit once the linkage rod is removed from the car.

VIEW INFORMATIONAL VIDEO ABOUT THE LINKAGE ON CARS EQUIPPED WITH A 6 SPEED -->HERE
NOTE: This video helps you have a better understanding of the linkage and how this shift rod would be removed for replacement. However, this video was done on a B5 S4 which has the same basic design and works in the same fashion, the B6/B7 A4 linkage just looks a little different and has a shorter cross rod.

PICTURE OF THE JHM LINKAGE UPGRADE FULLY ASSEMBLED -->HERE


NOTE: Some cutting of your OEM linkage rod is required, other than that, this is a full bolt in kit.

For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.


This product fits the following vehicles:
Make Model Chassis Engine
Audi A4 B7 (2005.5-2009) all
Audi A4 B6 (2002-2005) all
Audi A6 C6 (2005.5-2011) all
Reviews
Write Your Own Review
You're reviewing: JHM Solid Linkage Upgrade for C6 A6 & B6-B7 A4, 2004-on (6-Speed) - 01X-02X
Off-road Use

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Prop 65

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov

Q and A

Product Questions

No questions yet. Be the first to ask the question!
You may also be interested in the following product(s)
JHM Pushdown reverse spring kit for all 6-speed JHM shifters JHM Pushdown reverse spring kit for all 6-speed JHM shifters

$5.95
JHM 6-Rib Alternator Belt Conversion Kit for B7-RS4 w 4.2L FSI (32v) JHM 6-Rib Alternator Belt Conversion Kit for B7-RS4 w 4.2L FSI (32v)

$459.95
JHM HD Overdrive (187mm) Lightweight Supercharger Crank Pulley for B8-B8.5, S4-S5, C6-C7 A6-A7 and B8 Q5-SQ5 3.0T FSI JHM HD Overdrive (187mm) Lightweight Supercharger Crank Pulley for B8-B8.5, S4-S5, C6-C7 A6-A7 and B8 Q5-SQ5 3.0T FSI

$324.95
Front Rotors (pair) JHM 2-piece Lightweight for S6-S8 V10 Front Rotors (pair) JHM 2-piece Lightweight for S6-S8 V10

$1,299.95
Company Info

Call Us:
209-968-0077

E-Mail Us:
sales@jhmotorsports.com

Find Us:
14150 S. Harlan Rd. Lathrop, CA 95330
General Infomation
© 2006 to present day JH Motorsports, Inc. All Rights Reserved.

JH Motorsports is not affiliated with or endorsed by Audi AG, Audi of America, Volkswagen AG, or Volkswagen of American or any other car company mentioned or whose logos are displayed in these web pages or our store. Audi®, Quattro®, Avant®, A4®, S4®, A6®, RS4®, RS6®, Allroad®, TT®, and Tiptronic® are trademarks of Audi AG. Volkswagen®, VW®, Golf®, Jetta®, Passat® and Beetle® are trademarks of Volkswagen AG. While we try to keep everything current, JH Motorsports is not responsible for errors in pricing on this web site. All prices are in US Dollars.

Some of these modifications and or parts are intended for off-road use only and may violate Federal or your State emissions standards. Also, end user assumes all risk with product performance and installation. JH Motorsports is not responsible for any bodily or mechanical harm, etc. as a result of use or misuse of any products.