- JHM Intake Manifold Flap Delete Plug Kit for B7-RS4 4.2L FSI V8
JHM Intake Manifold Flap Delete Plug Kit for B7-RS4 4.2L FSI V8
This is a high quality RS4 Flap Delete Plug Kit that we have put together to insure a clean and simple deletion of the OEM Intake Manifold Flaps. This Flap Delete Kit goes hand in hand with the new RS4 Flap Delete option available with our renown B7-RS4 ECU Tuning Software. When coupled with our software, you will no longer have the check engine light and the fault codes associated with failing intake manifold flap position sensors and more commonly broken or wallowed out intake manifold flap linkages and arms.
These are the fault codes that our Flap Delete software option will eliminate:
- P2015 - 008 - Implausible Signal - Intermittent - MIL ON 008213 - Intake Manifold Flap Position Sensor (Bank 1)
P2020 - 008 - Implausible Signal - Intermittent - MIL ON 008224 - Intake Manifold Flap Position Sensor (Bank 2)
Choosing to remove the flaps is a good option if the flaps in your manifold are no longer functioning as this will prevent high RPM power loss. Broken or wallowed out linkage arms are not able to open when they need to be, which will cause performance related issues.
An additional benefit that this plug kit offers is that the surface area of these plugs are more than double of the stock plugs, allowing better retention in the intake manifold.
This Kit Includes 16 New Manifold Plugs (two per intake port).
For more information regarding our RS4 Performance Software and the Flap Deletion Software, please go to our "Engine and Performance" Section.
NOTE: Permatex High Tack 80062 is recommended for the installation of these plugs.
For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.
|Audi||RS4||B7 (2006-2009)||4.2l V8 32v FSI|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov
Does this product remove the dreaded threat of the engine blow out associated with the valve screws falling into the engine?