Select Vehicle From Dropdown

Front Rotors (pair) BBK -JHM 350mm for Cayenne Caliper (Brembo 6 piston 18z) on MK 5-6 VW Golf, GTI, R32, Jetta

SKU: JHM-1025x350x32mk56

$899.95

Details
Details

The Original Audi Lightweight Rotors engineered and manufactured in the USA since 2010!

 

 


Click to enlarge picture
Audi S8 Brake Rotors (Rear) | 2-piece Lightweight

Due to popular demand, all of our 2-piece, lightweight rotors will now come with black anodized rotor hats featuring Type 3, hard anodizing, the highest quality and hardest anodizing available for aluminum. This will make the rotor hats more resistant to fade and wear and will hide brake dust better. Due to popular, demand all lightweight rotor rings will also feature zinc plating. This high quality coating will slow the effects of corrosion and keep your rotor rings looking good through the winters.

IN STOCK AND READY TO SHIP!

 

FINALLY a low cost front BBK (Big Brake kit) solution for your MKV MKVI that uses the popular Porsche Cayenne caliper (6-piston Brembo) while clearing most OEM 18" wheels and most aftermarket 18" wheels as well. 

 

Click to enlarge picture
VW Front Rotors/ 330mm, Cayenne Caliper VW MKV MKVI

 


-Rotor Weight: Stock = JHM = 17lbs(each)
-Rotor Cooling Air-gap: JHM = 18.5mm(.728") 
-Rotor Cooling Center Fin Design: Stock = Straight Fin, JHM = Airfoil - MORE EFFICIENT for better cooling
-Bolt pattern: - SAME (fits like an OEM rotor would)

 

Why the Porsche Cayenne caliper? With its 6-piston design and MASSIVE brake pads it is a strong performer. Also it bolts right up to your spindles with NO brackets. All you need is some bolts, nuts, brake lines and JHM rotors and you have a 350mm BBK. Being that it is an OEM part they are readily available and can be found used for great prices.

 

INSTALLATION NOTES --> CLICK HERE

 

INCLUDES: 2 x JHM 2-piece Lightweight Slotted Front Rotors and 2 x rotor hat to hub adpaters that MUST be installed between the rotor hat and hub BEFORE putting the rotor on.

 

HOW TO MAKE THIS ROTOR WORK WITH THE CAYENNE or TOUAREG 17Z CALIPER:

  1. Buy SBLK1500 stainless brake lines from JHM to connect the cayenne caliper to your factory lines.
  2. Buy BTKPorscheC bolt kit for cayenne calipers with adapter bushings to connect the cayenne caliper to your spindle. (they need to be installed in a specific way, see pic in zip below)
  3. Buy 350mm cayenne brake bads, just search cayenne 350mm on our site, we have several options.
  4. Buy 7L0907637 sensor for brake pad sensor system to work
  5. Buy a pair of new or used 18z Cayenne, Touareg or Q7 calipers

 

Outer ring specs:
We worked closely with a race brake manufacturer that supplies many NASCAR racers and a couple major brake kit companies. Due to their expertise we chose to have them build us the outer rings to our specs to fit the B6-B7 S4-A4 with a Cayenne caliper bolted on. 12 attachment points for durability and strength.

 

Center hat specs:
We CNC machine the Aluminum center hats in house based on their recommended materials and thicknesses for durability. 12 attachment points for durability and strength. We also engrave JHM in them in 3 locations equal from each other, it looks clean and doesn't jump out or look tacky.

 

Click to enlarge picture
Audi B8 S4-S5 Brake Rotors (Rear) 2-piece Lightweight

 

 

Note - This brake upgrade only fits under 17" wheels or larger. May need wheel spacers with some wheels. 

 

For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.



This product fits the following vehicles:
Make Model Chassis Engine
Volkswagen Golf MK V (2006-2009) all
Volkswagen GTI MK V (2006-2009) all
Volkswagen Golf MK VI (2010-2014) all
Volkswagen GTI MK VI (2010-2014) all
Volkswagen Golf R MK VI (2012-2013) 2.0t FSI
Volkswagen Jetta MK VI (2011-Present) all
Volkswagen Golf R32 MK V (2008) 3.2l VR6 24v
Reviews
Write Your Own Review
You're reviewing: Front Rotors (pair) BBK -JHM 350mm for Cayenne Caliper (Brembo 6 piston 18z) on MK 5-6 VW Golf, GTI, R32, Jetta
Off-road Use

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Prop 65

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov

Q and A

Product Questions

No questions yet. Be the first to ask the question!
You may also be interested in the following product(s)