Select Vehicle From Dropdown

Driveshaft Spacer Kit for 0A3 or 01E Manual Conversion-Swap for C5 A6 and S6 w 4.2l V8 and 5hp24 5-speed Tiptronic transmission

SKU: JHM-C5A6S6dsSpacer

$150.00

Sale Price $119.96

Details
Details
This is needed to swap your C5 A6, C5 S6 with 4.2l V8 and 5hp24 5-speed tiptronic transmission to a 01E B5-C5 2.7t transmission or the more modern 0A3 B6-B7 S4 transmission!
NOTE: To install a 0A3 B6-B7 S4 transmission you will need the JHM speedometer converter, JHM trans mount brackets, JHM CV Shaft spacer this product, parts from the list below and a software solution, contact us for details.

Spacer allows for use of your factory installed driveshaft. The driveshaft spacer is CNC'd out of 6061 aluminium and machined to aircraft tolerances. Balance tested to over 10,000 rpm's.

Includes 6 bolts and 6 washers to mount to the transmission.

Check out this product page for more info and other parts needed for the 0A3 swap -> HERE>



This product fits the following vehicles:
Make Model Chassis Engine
Audi S6 C5 (2002-2003) 4.2l V8 40v
Audi A6 C5 (1998-2004) 4.2l V8 40v

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Q and A

Product Questions

Sort by ASC
DO you have the dimensions of this spacer?
0
Will this work for a C5 RS6 when doing a manual swap?
0
You may also be interested in the following product(s)