- Rear Differential Carrier Mount Insert Kit,(034) B6/B7 Audi A4/S4/RS4, Billet Aluminum
Rear Differential Carrier Mount Insert Kit,(034) B6/B7 Audi A4/S4/RS4, Billet Aluminum
Front Rotors (pair), JHM 2-piece Lightweight for S6-S8 V10$1,049.95Add to Cart | Wishlist
Front Rotors(pair)- JHM 2-piece Lightweight for B6-B7 S4 2004 up$695.00Add to Cart | Wishlist
JHM Oil Separator Heater Bypass Kit for B8-S5 4.2L FSI V8$11.95Add to Cart | Wishlist
034Motorsport is pleased to present our new Billet Aluminum Rear Differential Carrier Mount Insert Upgrade for the B6/B7 Audi A4/S4/RS4! The factory Audi rear differential carrier bushings have voids in the rubber damping medium, which results in excessive rear differential movement (twisting) under load. This movement allows for unwanted drivetrain slop (and sometimes clunks) that can be observed when accelerating, decelerating, and shifting.
These billet aluminum inserts are designed to fill the voids in the factory B6/B7 Audi A4/S4/RS4 rear differential carrier mounts, and limit rear differential movement without sacrificing ride quality or introducing any additional noise, vibration, or harshness into the cabin. By filling the voids in the factory mounts, these inserts eliminate the associated slop and ensures that you're experiencing smoother shifting and throttle transitions, and an improved driving experience.
Installation is very simple, can be performed in minutes, and is completely reversible.
- CNC-Machined Billet Aluminum Construction with Clear Anodized Finish
- Application-Specific Design Featuring Stainless Steel Securing Washers
- Engineered to Fill Voids In Factory Rear Differential Mounts
- Drastically Reduces Rear Differential Movement During Shifting, Acceleration, and Deceleration
- Improves Shifting Feel, Resulting in Crisper Shifts
- Will Not Cause Additional NVH Transfer Inside Cabin
- Easy, Straightforward Installation Takes Minutes!
- 034Motorsport Billet Aluminum Rear Differential Carrier Mount Insert Pair
- High Strength Stainless Steel Securing Washer Pair
- 2002 - 2005 Audi A4 (B6)
- Quattro Models Only
- 2003 - 2005 Audi S4 (B6)
- 2005.5 - 2008 Audi A4 (B7)
- Quattro Models Only
- 2005.5 - 2008 Audi S4 (B7)
- 2006 - 2008 Audi RS4 (B7)
- 8E0 599 257K / 8E0599257K
|Audi||RS4||B7 (2006-2009)||4.2l V8 32v FSI|
|Audi||S4||B6 (2003-2005)||4.2l V8 40v|
|Audi||S4||B7 (2005.5-2009)||4.2l V8 40v|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov
Select options & add to cart to view final price