- Motor Mounts - Pair (Motorsport Line) for B6-B7 S4, B7-RS4, C5 A6-S6-allroad 4.2L, 10MM & 8MM Hardware
Motor Mounts - Pair (Motorsport Line) for B6-B7 S4, B7-RS4, C5 A6-S6-allroad 4.2L, 10MM & 8MM Hardware
Exhaust - Race Pipe - Stainless Steel (JHM) for B9 S4-S5 3.0T$1,199.95Add to Cart | Wishlist
JHM R Series Lightweight Flywheel (Chrome-Moly Forged) and Clutch Combo for B7-RS4
Select options & add to cart to view final price
Front Rotors (pair), JHM 2-piece Lightweight for S6-S8 V10$1,049.95Add to Cart | Wishlist
Front Rotors(pair)- JHM 2-piece Lightweight for B6-B7 S4 2004 up$695.00Add to Cart | Wishlist
This is 034Motorsport's new line of MOTORSPORT Mounts made specifically for B6-B7 V8 Audis. These are a pair of Engine Mounts for B6-B7 Audi S4s and B7-RS4s.
034Motorsport's Motorsport Engine Mounts are the new standard in track performance. Their mounts are engineered with racing in mind and manufactured from billet aluminum and high-durometer rubber for the ultimate in performance and durability.
The result is a locked-down drivetrain, solid shifting, and virtually no wheel hop. Although these Motorsport Line mounts will cause a noticeable increase in noise, vibration, and harshness (NVH) inside of the cabin of a 4 cylinder or 6 cylinder car the increase on the smoother running V8s isn't that bad. So if you are looking for a fully-encapsulated mount that will give you extremely limited engine movement, this is the mount for you!
- Manufactured from Billet Aluminum and High-Durometer Rubber
- Lifetime Warranty **
- Rebuildable Design
- Available with 8mm and 10mm Hardware
- Reduced Drivetrain Slop
- Decreased Engine Movement Under Load
- More Direct Power Transfer
- Improved Shifting Feel
- Complete Drop-In Replacement of Factory Engine Mounts
- Sold in Pairs
Please note: Available with 8mm and 10mm mounting hardware. The stock mounts use 8mm studs. We recommend upgrading to 10mm studs if you plan on launching your car and/or drag racing. Upgrading to 10mm studs will require drilling the stock engine mount brackets. These mounts cannot pivot once installed and bolted firmly in place.
- OPTIONAL: Electronic circuitry disabled, if you do not want to have codes stored in your ECU please purchase 034-708-0000 for a resistor to install. 1 per mount needed. This does NOT cause a Check Engine light it is just a soft code that some people do not like to have.
**Limited Lifetime Replacement Warranty against failure from manufacturing defects. Applicable to the original purchaser only. If any part of the mount fails under normal use, upon 034Motorsport approval, replacement part(s) will be shipped at no charge to the customer for installation.
For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.
|Audi||allroad||C5 (2001-2005)||4.2l V8 40v|
|Audi||A6||C5 (1998-2004)||4.2l V8 40v|
|Audi||S4||B6 (2003-2005)||4.2l V8 40v|
|Audi||S4||B7 (2005.5-2009)||4.2l V8 40v|
|Audi||RS4||B7 (2006-2009)||4.2l V8 32v FSI|
|Audi||S6||C5 (2002-2003)||4.2l V8 40v|
- Happy! Had to get used it it...
To be clear I am very happy with the performance of the mounts thus far! much firmer and makes the car feel solid. I had to get used to the side effects of the mounts which honestly freaked me out a bit. You feel a LOT more of the engine compared to stock. Sometimes at idle the engine just ever so slightly dips a little lower is the RPMs and "shudders" (for a lack of a better term). Before I didn't feel much vibration, now it is quite evident when this happens. I want to say I can feel the individual pulses at idle. around 1,500rpm I definitely feel more vibration but otherwise it isn't bad at all! Haven't gone above 4,500rpm because I'm wearing in the new chain tensioners.
I will have to find a way to keep the sun visors from rattling now..lol Review by Garrett (Posted on 3/14/2018)
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov
Select options & add to cart to view final price