- Front Subframe Locking Collar Upgrade Kit,(034)for MQB 8V/8S Audi A3/S3 & TT/TTS, Stainless Steel
Front Subframe Locking Collar Upgrade Kit,(034)for MQB 8V/8S Audi A3/S3 & TT/TTS, Stainless Steel
034Motorsport is pleased to present the Stainless Steel Subframe Locking Collar Upgrade Kit for the 8V Audi A3/S3 & 8S Audi TT/TTS! Designed to center the subframe using precision-engineered stainless steel insert bushings and large-diameter bolts, this kit eliminates clunks caused by the subframe shifting, and increases chassis rigidity for improved handling performance.
This kit addresses subframe clunk/pop/creak which presents itself when taking slow turns, entering driveways, coming to a stop, and starting from a standstill. These locking collars and new factory bolts are a permanent, affordable solution to address the fundamental issue with the factory subframe design.
The upper and lower collars in our kit are specifically machineded to locate the subframe and bolts perfectly and ensure hassle-free installation. The supplied bolts feature factory-correct tips and thread engagement points to prevent thread stripping. Unlike other kits on the market that use softer alloys, our 8V Audi A3/S3 & 8S Audi TT/TTS Subframe Locking Collars are made from stainless steel to prevent deformation and ensure a lifetime of performance.
Installation is very straightforward and can be performed in approximately one hour. No permanent modification to the subframe is required, and this upgrade is completely reversible.
- CNC-Machined Stainless Steel Locking Collars
- Application-Specific Design for Both Upper & Lower Locking Collars
- Engineered to Properly Locate (Center) Factory Front Subframe & Eliminate Shifting/Clunks
- Includes New Factory Subframe Bolts
- Improves Chassis Rigidity & Handling Performance
- Addresses Volkswagen Subframe Knocking Noise Permanently!
- Will Not Cause Additional NVH Transfer Inside Cabin
- Easy, Straightforward Installation Takes Approximately 1 Hour!
- 034Motorsport Stainless Steel Upper Front Subframe Locking Collars (Set of 2)
- 034Motorsport Stainless Steel Upper Rear Subframe Locking Collars (Set of 2)
- 034Motorsport Stainless Steel Lower Subframe Locking Collars (Set of 4)
- Subframe Bracket Spacing Washers (Set of 4)
- Factory Replacement Subframe Bolts (Set of 4)
- 2015 - Present Audi A3/S3 (8V - MQB)
- 2016 - Present Audi TT/TTS (MkIII - MQB)
|Audi||S3||8V (2015-Present)||2.0t TFSI|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov