Select Vehicle From Dropdown

FRONT STRUT BRACE (034MOTORSPORT), B8 AUDI A4/S4, ALLROAD, BILLET ALUMINUM

SKU: 034-603-0010
$460.00

Details
Details

034Motorsport is proud to offer our Billet Aluminum Front Strut Brace for the B8 Audi A4/S4 & Allroad! These Audi models do not come with a strut brace from the factory, allowing for lateral deflection of the strut towers and chassis flex under hard cornering. While the B8 chassis comes from the factory with a support bar located behind the fire wall, this component is not significantly structural to the chassis and allows strut tower deflection. This deflection can be observed as imprecise steering input and a vague, disconnected feeling from the front end due to undesired suspension geometry changes.

The 034Motorsport Strut Brace incorporates an extremely rigid billet aluminum center section that attaches to both strut towers and to the firewall in two locations, improving the vehicle's steering feel and handling performance. This robust chassis reinforcement is machined from 6061-T6 billet aluminum, and engineered to be a comprehensive upgrade by limiting lateral strut tower deflection and maintaining proper suspension geometry under heavy cornering. The end result is a significantly more rigid front end that provides precise, consistent feedback through the steering wheel and ensures that you enjoy a more connected driving experience.

This strut brace was thoroughly tested by 034Motorsport on in-house B8 and B8.5 Audi S4 Development Vehicles before release.

FEATURES:

  • Truss Design is Lightweight and Extremely Rigid
  • 6061-T6 Billet Aluminum Construction with Clear Anodized Finish
  • Attaches to Both Strut Towers and the Firewall in Two Locations
  • Engineered to Enhance Handling Dynamics and Performance
  • Improves Steering Feel, Consistency, and Precision

WHAT'S INCLUDED:

  • 034Motorsport Billet Aluminum Front Strut Brace Chassis Reinforcement
  • Strut Tower Brackets
  • Strut Bar Brackets
  • Transfer Punch
  • Transfer Punch Guides (4)
  • Mounting Hardware


This product fits the following vehicles:
Make Model Chassis Engine
Audi A4 B8-B8.5 (2009-2016) all
Audi A4 B8-B8.5 (2009-2016) all
Audi allroad B8-B8.5 (2013-2016) 2.0t TFSI
Reviews
Write Your Own Review
You're reviewing: FRONT STRUT BRACE (034MOTORSPORT), B8 AUDI A4/S4, ALLROAD, BILLET ALUMINUM
Off-road Use

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Prop 65

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov

Q and A

Product Questions

No questions yet. Be the first to ask the question!