• Supercharger DRIVE Pulley Upgrade 57.75mm (APR) for B8-B8.5, S4-S5, C7 A6-A7 and B8 Q5-SQ5 3.0T FSI
Select Vehicle From Dropdown

Supercharger DRIVE Pulley Upgrade 57.75mm (APR) for B8-B8.5, S4-S5, C7 A6-A7 and B8 Q5-SQ5 3.0T FSI Zoom

Supercharger DRIVE Pulley Upgrade 57.75mm (APR) for B8-B8.5, S4-S5, C7 A6-A7 and B8 Q5-SQ5 3.0T FSI

Be the first to review this product

SKU: APR-MS100135
$223.00

Featured Products

Details
Details
If you are looking to run a DUAL PULLEY, AKA Stage 2+ setup with pulley ratio at or near 3.27 check out our NEW One And Done (OAD) 207mm crank pulley. This crank pulley does NOT require a supercharger pulley to get the 3.2x Dual Pulley ratio. This approach also keeps the stock larger blower pulley for better belt grip and no need to install 2 parts. Just install our crank pulley and you are done. You save time/money on labor as well. SKU: JHM-06E105251F-207mm NOTE: Block clearance is required, see our product page for the 207mm pulley for notes and which belt to purchase.

ATTENTION! Don't forget to check out our Heat Exchanger upgrades (HX) when upgrading your pulleys. A faster spinning blower increases boost pressure and heat so upgrading your heat exchanger is a great upgrade for cooler IATs which is safer and helps you make more power as well.

APR presents the 3.0 TFSI Supercharger Drive Pulley Upgrade! (Belt sold separately)

APR's Supercharger Drive Upgrade dramatically increase horsepower and torque by increasing the rotational speed of the factory supercharger. APR's Stage II Pulley ECU Upgrade makes the necessary engine management adjustments to handle the increased supercharger speeds, and in turn allows the engine to create more power. The pulleys are sold separately, allowing for multiple levels of performance, each of which builds upon the other. Finally, when combined with APR's Ultracharger Throttle Body Upgrade in a dual pulley setup, the system is alleviated of power robbing inlet restrictions, allowing the engine to achieve exciting new levels of performance!

Click to enlarge picture

Click to enlarge picture

APR's Supercharger Drive Pulley Upgrade decreases the diameter of the factory pulley from 63.25mm to 57.75mm, which in turn spins the supercharger 9.5% faster. This results in a healthy bump in horsepower and torque across the entire RPM range with the supercharger operating at a higher rate of speed. The pulley is CNC machined from billet stainless steel, e-coated black for an OEM appearance and is press fitted to the factory supercharger unit.

For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.


Notice:

Off-road use ONLY: THIS PRODUCT IS FOR RACING COMPETITION ONLY AND IS NOT LEGAL FOR USE IN HIGHWAY OR STREET VEHICLES OR OTHER NON-RACING COMPETITION OFF-ROAD VEHICLES. BY PURCHASING THIS PRODUCT YOU ACKNOWLEDGE ITS INTENDED USE.

This product fits the following vehicles:
Make Model Chassis Engine
Audi S4 B8-B8.5 (2010-2016) 3.0t V6 24v SC
Audi S5 B8-B8.5 (2008-2017) 3.0t V6 24v SC
Audi A7 C7 (2012-Present) 3.0t V6 24v SC
Audi A6 C7 (2012-Present) 3.0t V6 24v SC
Audi Q5 B8 (2009-Present) 3.0t V6 24v SC
Audi SQ5 B8 (2014-Present) 3.0t V6 24v SC
Reviews
Write Your Own Review
You're reviewing: Supercharger DRIVE Pulley Upgrade 57.75mm (APR) for B8-B8.5, S4-S5, C7 A6-A7 and B8 Q5-SQ5 3.0T FSI
Off-road Use

By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)

Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system.

Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.

As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).

Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.

Prop 65

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov

Q and A

Product Questions

No questions yet. Be the first to ask the question!
Company Info

Call Us:
209-968-0077

E-Mail Us:
sales@jhmotorsports.com

Find Us:
14150 S. Harlan Rd. Lathrop, CA 95330
General Infomation
© 2006 to present day JH Motorsports, Inc. All Rights Reserved.

JH Motorsports is not affiliated with or endorsed by Audi AG, Audi of America, Volkswagen AG, or Volkswagen of American or any other car company mentioned or whose logos are displayed in these web pages or our store. Audi®, Quattro®, Avant®, A4®, S4®, A6®, RS4®, RS6®, Allroad®, TT®, and Tiptronic® are trademarks of Audi AG. Volkswagen®, VW®, Golf®, Jetta®, Passat® and Beetle® are trademarks of Volkswagen AG. While we try to keep everything current, JH Motorsports is not responsible for errors in pricing on this web site. All prices are in US Dollars.

Some of these modifications and or parts are intended for off-road use only and may violate Federal or your State emissions standards. Also, end user assumes all risk with product performance and installation. JH Motorsports is not responsible for any bodily or mechanical harm, etc. as a result of use or misuse of any products.