- JHM DSG Aluminum Lightweight Flywheel (DL501) for B8-B8.5 S4, S5, RS5 and C7 S6, S7 w 3.0T, 4.0T and 4.2L
JHM DSG Aluminum Lightweight Flywheel (DL501) for B8-B8.5 S4, S5, RS5 and C7 S6, S7 w 3.0T, 4.0T and 4.2L
Exhaust - Race Pipe - Stainless Steel (JHM) for B9 S4-S5 3.0T$1,199.95Add to Cart | Wishlist
JHM R Series Lightweight Flywheel (Chrome-Moly Forged) and Clutch Combo for B7-RS4
Select options & add to cart to view final price
INTRODUCING THE JHM DL501 DSG LIGHTWEIGHT FLYWHEEL!!!
After years of research, development, prototyping, and testing lightweight flywheels, we are finally ready to release our highly anticipated DSG Lightweight Flywheel for the DL501 DSG Transmission commonly found in the B8 S4-S5-RS5, C7 S6-S7! We have been developing Lightweight Flywheels for Audis for over 10 years and we are pleased to now offer lightweight solutions for DSG Transmissions.
0-60MPH Testing on our in house B8 RS5 4.2L
We saw immediate gains of .26 seconds in our 0-60 after installing our Lightweight DSG Flywheel. Our RS5 reached 60mph almost 14ft sooner than before!
WHY A LIGHTWEIGHT FLYWHEEL?
Replacing the OEM, cast-iron, dual-mass flywheel with a single-mass, lightweight, aluminum piece reduces the overall weight of the rotating assembly of the motor. This frees up power in the motor and leads to increased throttle responsiveness. Changing the upper portion of the OEM flywheel to a single-mass unit also eliminates the potential for failure of the dual-mass unit. This is especially important for high-horsepower cars.
JHM LIGHTWEIGHT FLYWHEEL SPECIFICATIONS:
At JHM, we have weighed over a dozen OEM flywheels. We have seen a wide range of weight variances even on flywheels with the same part number! On average, the JHM Lightweight Flywheel weighs 10-12 lbs less compared to the OEM DL501 Flywheel. Our JHM DSG Lightweight Flywheel weighs just over 13lbs and is nearly 50% lighter depending on the weight of your heavy OEM Flywheel.
- JHM Aluminum and Machined Steel 2-Piece Lightweight Flywheel Assembly
- 6x Flywheel to Flexplate Bolts
For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.
|Audi||RS5||B8-B8.5 (2011-2015)||4.2l V8 32v FSI|
|Audi||S7||C7-C7.5 (2013-Present)||4.0t V8 32v|
|Audi||S6||C7-C7.5 (2013-Present)||4.0t V8 32v|
|Audi||S5||B8-B8.5 (2008-2017)||3.0t V6 24v SC|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov
Select options & add to cart to view final price