- Front Control Arm Kit (034) Density Line for B5-C5 A4-S4-A6, Passat w/ Steel Uprights
Front Control Arm Kit (034) Density Line for B5-C5 A4-S4-A6, Passat w/ Steel Uprights
JHM Helical Rear LSD for B6-B7 A4 S4 Manual Transmission (EXZ, ETS, HNP, HUQ) - Pre-built Outright Sale - Only One Left$1,799.95
Click to enlarge picture
Hardware Kit Now Included!!!
Click to enlarge picture
Does your B5 Audi A4/S4 or C5 A6 have that "not so fresh" feeling? Does it clunk and clack over driveways and speed bumps? Does it have the steering response of a '59 Chebby? It's ok, your undercarriage just needs a little work, and it won't require any cream and you're not the only girl on the block, this is a common problem with B5 A4/S4/Passat as well as C5 A6 chassis cars. Fix it once and for all with a complete kit of all front suspension links. No, these are not parts for 7 cars which it may appear, your car really uses this many links to create the sharp handling and buttery smooth ride, just make sure they are tight for slop free, fresh handling. Save a ton of money by buying the complete kit over piecing together parts, OE arms, these are not performance upgrades, just new factory replacements. INCLUDES: All 8 control arms for the front, both sway bar end links, All associated bolts (12) and nuts. Don't be fooled by cheap Chinese Ebay arm kits, 034 arm kits are the real deal and they stand behind them with a 1-year replacement warranty from the time of purchase*. NOTE 1: This kit is for late B5-S4s and C5-A6 models with STEEL uprights. Cars with aluminum uprights need 2 different lower control arms. Go back one section to view the "Alum. Uprights" Kit. You can easily verify if your car has these housings if your suspension uprights are made out of aluminum. NOTE 2: The complete hardware kit with all new nuts and bolts is now included! NOTE 3: This kit is NOT for C5 allroads. They have different lower control arms than C5 A6s and B5s. *NOTE 4: To ensure a long life for these control arms, when they are installed, it is IMPERATIVE that the suspension be compressed to statis ride height before any suspension pivot bushings are tightened. If this is not done, bushings will tear as the twisting forces on them will be much higher than is intended. If you have any questions about this, please contact us to verify, if this is not done any warranty will be voided. NOTE about VW Passat:All Passats with VIN from 000000 - 072000 take part number have steel uprights. All Passats with VIN from 072001 - end of B5/B5.5 have steel uprights but take aluminum upright style arms. Please note when ordering. Note, consider upgraded solid tie rod ends as well:
For shipping quotes: Please sign in or join then put the items you want in your shopping cart and proceed to checkout.
|Audi||S4||B5 (1997-2002)||2.7t V6 30v|
|Audi||RS4||B5 (1999-2001)||2.7t V6 30v|
By Purchasing any Off-Road use ONLY products from JH Motorsports, Inc. I acknowledge and understand the following disclosure. (This notice is located at the bottom of the page description of affected products on our website.)Vehicle Code § 27156:
(b) No person shall operate or leave standing upon a highway a motor vehicle that is required to be equipped with a motor vehicle pollution control device under Part 5 (commencing with Section 43000) of Division 26 of the Health and Safety Code or any other certified motor vehicle pollution control device required by any other state law or any rule or regulation adopted pursuant to that law, or required to be equipped with a motor vehicle pollution control device pursuant to the National Emission Standards Act (42 U.S.C. Secs. 7521 to 7550, inclusive) and the standards and regulations adopted pursuant to that federal act, unless the motor vehicle is equipped with the required motor vehicle pollution control device that is correctly installed and in operating condition. No person shall disconnect, modify, or alter any such required device.
(c) No person shall install, sell, offer for sale, or advertise any device, apparatus, or mechanism intended for use with, or as a part of, a required motor vehicle pollution control device or system that alters or modifies the original design or performance of the motor vehicle pollution control device or system. Health and Safety Code § 43000:
43001. The provisions of this part shall not apply to:
(a) Racing vehicles.
As the aforementioned code sections outline, it is against the law to operate or use a vehicle on public streets or highways with modified, altered, or disconnected motor vehicle pollution control devices. This may include but is not limited to, Evaporative Fuel Controls, Catalysts, DPF, PTOX, PCV Systems, Exhaust Gas Recirculation Systems, Oxygen Sensors, Thermostatic Air Cleaners, Air Intake Systems, Fuel Injectors, Regulators, Adjustable Cam Gears, ECU Programming, Mapping, or other Computer Modifications. Air Pumps, Air Injection, Timing, and any other Emission System Modification(s).
Purchaser acknowledges and certifies to JH Motorsports Inc., that Purchasers vehicle will only be used for racing applications or off road vehicle use only. Purchaser requests these modifications for the purpose of enhancing the vehicle for competitive Racing Applications and will not use this vehicle on public streets or highways. Purchaser agrees to indemnify JH Motorsports Inc., all employees, officers, owners, and subsidiaries for any civil or criminal liability arising out of use of Purchasers vehicle on public streets or highways as Purchaser has been duly notified of the laws and regulations regarding disconnecting, alteration, or modification of a vehicle’s pollution control devices. Purchaser understands and has been advised the driving of a vehicle on public streets or highways could result in criminal or civil penalties.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov